Sorry, this article is only available in Русский.
 |
 |
UDC 621.787.4
THE CHANGE OF RADIUS OF THE GROOVE ON LENGTH OF THE PROCESSED SURFACE DURING DEEP GRINDING OF PREPARATION FROM THE TITANIC ALLOY
Nosenko Sergey Vladimirovich1, Kremenetsky Leonid Leonidovich2, Morozova Lilia Konstantinovna3
1Volzhskiy Polytechnic Institute (branch) Volgograd State Technical University, Candidate of Technical Sciences, Associate Professor
2Volzhskiy Polytechnic Institute (branch) Volgograd State Technical University, graduate student
3Volzhskiy Polytechnic Institute (branch) Volgograd State Technical University, assistant
1Volzhskiy Polytechnic Institute (branch) Volgograd State Technical University, Candidate of Technical Sciences, Associate Professor
2Volzhskiy Polytechnic Institute (branch) Volgograd State Technical University, graduate student
3Volzhskiy Polytechnic Institute (branch) Volgograd State Technical University, assistant
Abstract
The research of regularities of change of the radius received by method of deep grinding is presented in article.
Keywords: abrasive tool, contact arch length, deep grinding, groove radius, wear of the tool
Article reference:
The change of radius of the groove on length of the processed surface during deep grinding of preparation from the titanic alloy // Modern technics and technologies. 2015. № 12 [Electronic journal]. URL: https://technology.snauka.ru/en/2015/12/8896
View this article in Russian
© If you have found a violation of copyrights please notify us immediately by e-mail or feedback form.
Contact author (comments/reviews)
Write comment
You must authorise to write a comment.
Если Вы еще не зарегистрированы на сайте, то Вам необходимо зарегистрироваться: