Sorry, this article is only available in Русский.
 |
 |
UDC 621.09.02.001.66
THE EFFECT OF DIFFERENT METHODS OF SURFACE TREATMENT IN THE DEEP HOLES AT THE RATE OF ROUGHNESS
Domnin Peter Valerevich1, Timofeeva Anna Aleksandrovna2
1Moscow State Technological University «STANKIN», Candidate of Engineering Sciences, Associate Professor
2Moscow State Technological University «STANKIN», Postgraduate
1Moscow State Technological University «STANKIN», Candidate of Engineering Sciences, Associate Professor
2Moscow State Technological University «STANKIN», Postgraduate
Abstract
The article describes the process of processing the surfaces of the deep holes. Article is devoted research of process of surface treatment in deep holes. Analysis of patent and literature showed that there are different methods and techniques designed for shaping surfaces in deep holes. The paper presents the summarized results of experiments on the influence of processing methods on the indicator of surface roughness. The smallest roughness is observed when BTA drilling method.
Keywords: collector, deep hole, drilling, roughness, steam generator, surface layer, surface treatment
Article reference:
The effect of different methods of surface treatment in the deep holes at the rate of roughness // Modern technics and technologies. 2016. № 3 [Electronic journal]. URL: https://technology.snauka.ru/en/2016/03/9686
View this article in Russian
© If you have found a violation of copyrights please notify us immediately by e-mail or feedback form.
Contact author (comments/reviews)
Write comment
You must authorise to write a comment.
Если Вы еще не зарегистрированы на сайте, то Вам необходимо зарегистрироваться: