Sorry, this article is only available in Русский.
UDC 621.914.22.001
ANALYSIS OF THE PARAMETERS CHIP CONTROL END MILL WITH EQUAL RESISTANCE SIDE AND END CUTTING BLADES WITH DIFFERENT INCLINATIONS OF THE CUTTING BLADES
Vodilov Andrey Valerievich1, Tcherkashin Valentin Pavlovich2
1Institute of instrumentation them. V.V. Tikhomirov, G. Zhukovskiy, Software Engineer
2"United Engineering Technologies" Moscow, Candidate. tehn. Sciences, Department of harvesters, chief calculations
1Institute of instrumentation them. V.V. Tikhomirov, G. Zhukovskiy, Software Engineer
2"United Engineering Technologies" Moscow, Candidate. tehn. Sciences, Department of harvesters, chief calculations
Abstract
The analysis of the theoretical roughness and the real (actual) roughness obtained result you measurements for milling end mill with equal resistance side and end cutting
Keywords: end mill, the surface roughness
Article reference:
Analysis of the parameters chip control end mill with equal resistance side and end cutting blades with different inclinations of the cutting blades // Modern technics and technologies. 2013. № 12 [Electronic journal]. URL: https://technology.snauka.ru/en/2013/12/2719
View this article in Russian
© If you have found a violation of copyrights please notify us immediately by e-mail or feedback form.
Contact author (comments/reviews)
Write comment
You must authorise to write a comment.
Если Вы еще не зарегистрированы на сайте, то Вам необходимо зарегистрироваться: